Manx SA7x Przewodnik Instalacji Pobierz pdf (Strona 202)

100

101

8.1 Troubleshooting the SF7x Storage Enclosure

Figure 8–6 Rx7x Disk ISE Orientation

NOTE TO

ILLUSTRATOR:

front panel for this

hardware is SHR_X1127_89

ISOL and reduced

17/64 (.265625)

Write

Protect

Fault

DSSI

Write

Protect

Ready

Fault

DSSI

Ready

NOTE TO ILLUSTRATOR:

This was created by

rotating SHR_x1074A_89_SCN

RW,Z120

SHR-X0128-90-SCN

THIS REPRESENTS

A RF72

SHR-X0135-90

SHR-X0136A-90

RF72

SKID PLATE

RETAINING CLIP

SKID PLATE

RETAINING TAB

LOCATION

SKID PLATE

GUIDE

4. Press all four Ready buttons on that OCP, one at a time.

5. If no Fault indicators are lit, then continue. If a Fault indicator is

lit, recycle the dc power once. If the failure appears again, refer to

Section 8.1.1.

6. Run the EVCXE or EVCXF programs to add the new disk ISE to the

conﬁguration and to change any disk ISE internal parameters, if necessary.

7. Update the system conﬁguration sheet.

8. Run DRVTST and DRVEXR (under DUP) to verify the correct operation of

the new disk ISEs.

9. Return the system to the user.

8–10 Installation Troubleshooting

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 319 320

Komentarze do niniejszej Instrukcji

Brak uwag

Manx SA7x Przewodnik Instalacji Strona 202

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Obudowy elektryczne Manx SA7x